Frequently Asked Questions

1. Does the GroundHog plow in reverse

A: Yes, but not as well as going forward. Reverse gives you the maneuverability to plow in tight places like pulpwood roads, firebreaks, and between pine rows.

2. Does the GroundHog work on hard and / or rough ground?

A: Yes. If your terrain is “difficult” the GroundHog will work. It just takes more passes. The GroundHog works well on hard, dry, rocky, grassy or any combination terrain. For best results plow in a combination of oblong circles, figure eights, and straight rows back and forth.

3. Does the plow work in wet bottom land?

A: Yes. The GroundHog will not bog down like a typical pull behind plow. The ATV controls the plowing depth. If your ATV can go through it the Groundhog can plow it.

4. Can I use the GroundHog if my ATV has a strong factory 1 ¼ or 2 inch receiver?

A: Yes. The GroundHog Model GH68P is all you need.

5. Can I use the GroundHog if my ATV only has a factory utility-hole assembly?

A: Yes. Most makes and model ATV’s can use the Tufline Part Number 13688 receiver hitch assembly. There are also receivers that can be ordered specific to ATV year, make, and model. See the compatibility section attached to this display or your owner’s manual. For more information visit www.groundhogdiscplow.com or call 1-800-566-1691.

6. Can I use the GroundHog if my ATV has light-weight factory receiver?

A: Yes. Most make and model ATV’s can use the Tufline Part Number 13688 receiver hitch assembly. There are also receivers that can be ordered specific to ATV year, make, and model. See the compatibility section attached to this display or your owner’s manual. For more information visit www.groundhogdiscplow.com or call 1-800-566-1691.

7. How well is the GroundHog made?

A: The GroundHog is made by Monroe-Tufline in Columbus, Mississippi USA. We’ve made professional agricultural and landscaping implements since 1958. Tufline entered the sportsman market in 2000. The GroundHog is our newest well built performance driven implement. It is made with high intensity heavy gauge steel. Each disc has a set of high speed bearings that are braded on. Discs are mounted on a 3/4inch one piece axle. This axle is then encased in a 1 inch steel pipe. This creates a closed system that does not require greasing. The GroundHog does not have ratchets. There are no tires to go flat and dry rot. The GroundHog is practically maintenance free. Replacement parts including discs are available.

8. Is the GroundHog just for food plots?

A: No. In addition to food plots the GroundHog is used for landscaping, preparing and maintaining fire breaks and weed control, grooming horse arenas and dirt tracks. If you need to till the ground the GroundHog will do it. In many cases it can be used to replace a tractor especially for smaller jobs.

9. Can I leave the GroundHog on my ATV while driving to my food plot site?

A: Yes you can in most instances. We call this feature “transport position.” However, every ATV is a little different. Here are some general guidelines: On some ATV’s you simply flip the GroundHog upside down and secure it in position with the tractor pin. On some ATV’s flip the GroundHog upside down, and adjust the plow head up or down until it clears the back of the ATV by removing and replacing the tractor pin. Then simply secure it in position with the tractor pin. On a few ATV’s you may not be able to use transport position due to the design of the read-end.

10. Does the Part Number 13688 receiver hitch assembly have to be perfectly level?

A: No. However, we do provide spacers. You should use them to get as close to level as possible.

11. Will I use all of the parts in Tufline Part Number 13688 receiver hitch assembly?

A: No, according to your specific ATV some parts may be left over.

12. If I use the Part Number 13688 receiver hitch assembly can I still use my trailer ball and leave the receiver on permanently?

A: Yes. After market Reese-type ball adapters are available and some will work fine. On others, the male part is to long and may have to be shortened or another hole drilled. You can also order a Reese-type ball adapter that is made for the GroundHog at www.groundhogdiscplow.com or by calling 1-800-566-1691.

13. Will the GroundHog work on my 2 x 4 ATV?

A: The GroundHog will work on most 2 x 4 ATV’s, but you can not plow as aggressively due to traction loss. The GroundHog is designed for and works best on 4 x 4 ATV’s.

14. Will the Groundhog work on both independent rear suspension and straight axle ATV’s?

A: Yes. We have tested it on both.


For more information about our Groundhog Disc Plow, or to speak to a representative now, contact us or call 1.800.566.1691.